Specifications of the H2OT SHOT Quartz Ultrapure Chemical Heater

HEATER	Patented heating system using infrared elements
SIZES	750 watts to 12,000 watts
VOLTAGES	208 volt to 480 volt, single or three phase Consult factory for specific wattage/voltage combinations available
TEMPERATURE LIMIT	185° C, depending on operating conditions
TEMPERATURE ACCURACY	1° C, depending on operating conditions
FLOW RATE	Up to 100 lpm (see chart)
PRESSURE RATING	50 PSIG working
MTBF	In excess of 20,000 hours
MTTR	10 minutes (with adequate access)
HEATING ELEMENT	IR halogen lamps
WETTED SURFACES	100% GE type 214 quartz
INLET/OUTLET	3/4" MNPT flare quartz connections
PURGE GAS	Patented system using 3.5 SCFM (min.) clean dry air (CDA) or nitrogen (N₂), 1/4" O.D. tube connector
STANDARD SAFETY FEATURES (requires controller interface)	Heater housing over-temperature shutoff and alarm ("J" type thermocouple and redundant bi-metallic snap switch) Purge gas verification and interlock
HOUSING	100% PTFE with seals made of Viton^Ò (non-wetted) Conforms to FM material standards
DIMENSIONS	10" W (254 mm) x 19" L (485 mm) x 7.8" H (198 mm)
CERTIFICATIONS	ETL certified to UL 499 standards CE compliant Conforms to Semi S2 and S3 standards
OPTIONS	• PLUMBING CONFIGURATIONS: Several available, consult factory • SOLUTION LEAK DETECTION: Capacitive-style leak detector • SOLUTION TEMPERATURE SENSOR SUBASSEMBLY: Fluoropolymer sheathed "J" type thermocouple in a flared "T" fitting • TEMPERATURE REGULATING SYSTEM with: Distributive zero-crossing SSR powered by open looped PID control (consult factory for details). Available: RS 232, RS 485, 4-20mA, or 0-10V interface. Liquid over-temperature shutoff and alarm
SHIPPING WEIGHT:	26 pounds (12 kg)

Wet Process Heating and Cooling Equipment

Specifications of the H₂OT SHOT Quartz Ultrapure Chemical Heater